How do you assign an ip on the interface. Trying to tftp to upgrade. i see it on the sh run but not on the sh int ip bri cmd. interface is up and up what am i missing?

Ethernet0 unassigned YES unset administratively down down
Ethernet1 unassigned YES unset up up

pixfirewall# sh run
: Saved
:
PIX Version 7.1(2)
!
hostname pixfirewall
enable password 8Ry2YjIyt7RRXU24 encrypted
names
!
interface Ethernet0
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet1
no nameif
security-level 1
ip address 192.168.2.170 255.255.255.0
!
passwd 2KFQnbNIdI.2KYOU encrypted
ftp mode passive
pager lines 24
no asdm history enable
arp timeout 14400
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00
timeout mgcp-pat 0:05:00 sip 0:30:00 sip_media 0:02:00
timeout uauth 0:05:00 absolute
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
telnet timeout 5
ssh timeout 5
console timeout 0
Cryptochecksum:00000000000000000000000000000000
: end

You need to assign names to interfaces. Then you can assign security levels. Once you've done that, start adding IP addresses.

hmmm... tried that before but didnt work rebooted and retried and it worked. Hey i'll take it thanks!